Lubricants

KATANA Habaki GL-4 75W-90 – synthetic gear oil for manual gearboxes and differentials requiring the use of API GL-4 gear oils.

Meets the requirements of:

API GL-4

MIL-L-2105

ZF TE-ML 17A

Read more

KATANA HabakiGL-4/5 75W-90 – synthetic technologygear oil for manual transmissions, drive axles, hypoid gears, transfer cases, and differentials of passenger cars, trucks, buses, loaders, construction equipment and other four-wheel drive vehicles that require the use of API GL-4 or GL-5 oils.

Meets the requirements of:

API GL-4/5

MIL-L2105 B/C/D

MIL-PRF-2105E

ZFTE-ML07A/16B/16C/16D/17A/17B/19B/21A

Read more

KATANA Habaki GL-5 75W-90 – synthetic gear oil for use in hypoid, heavy loaded transmissions of buses, tractors, trucks, off-highway equipment and passenger cars operating under a wide range of loads and speeds. It is also used in other units (front and rear differential, drive axle, front hub axle, front axle, front and rear hub reduction, transfer boxes), where a manufacturer recommends to use API GL-5 oils.

Meets the requirements of:

API GL-5

Volvo 97316

97310

Voith 3.325-339

ZF TE-ML 07A/16B/16C/16D/17B/19B/21A

MIL MIL-L-2105D

MB 235.0

MAN 342 Type M1

DAF, Renault

Read more

KATANA Habaki GL-5 LS 80W-90 – mineral allseason gear oil for use in heavy duty hypoid axles with limited-slip differential (self-locking). Specially designed for heavy loaded transmissions, requiring specific protection against wear and using special additivesfor friction limitation (Limited Slip).

Meets the requirements of:

API GL-5

MIL L-2105D

ZF TE ML 05C/12C/16E

MAN 342 N- 1

 

Read more

KATANA Sutorimu HLP-D 32–premium hydraulic oil for heavy dutyhydraulic equipment requiring the use of oils with the addition of dispersant (detergent) additives HLPD category.

Meets the requirements of:

DIN 51524 part 2 (HLP) except for emulsifying ability

Read more

KATANA Sutorimu HLP-Z 32 – premium zinc-free hydraulic oil for heavy  dutyequipment, requiring the use of DIN 51524 p.2 (HLP) oils. It has increased oil drain intervals due to increased hydrolytic stability.

Meets the requirements of:

DIN 51524 part2 (HLP)

Denison HF-0/HF-1/HF-2

CincinnatiMilacron P-68

Eaton 35VQ25

BoschRexroth 90220-01

Read more
1 2 3 4 5